Del ozone Spa-Eclipse Instalační manuál stáhnout pdf (Strana 12)

Eclipse Installation & Operations Manual

e. Be sure that the check valve has not become fouled with

debris. Disconnect the Ozone Tube from the injector. With the

pump running, cover the end of the injector with your thumb,

and feel for suction. If there is sufficient suction without the

check valve, replace the check valve with a new one.

4D-3 Symptom: Ozone Tube becomes yellow/brown and brittle.

1. The high concentration of ozone created by the Eclipse family of

ozone generators, as well as environmental conditions like UV

sunlight will tend to deteriorate the supplied Ozone Tube. This

is normal and acceptable, as long as the tubing doesn’t become

cracked and leak. Because of this, the Ozone Tube and Check

Valve should be replaced every year.

4D-4 Symptom: Can’t get ball to stay in the center of flowmeter.

1. The flowmeter provided is a general tool to setup flow to the

ozone generator. Flow will vary depending on pressures across

the injector, and therefore can be affected by things such as filter

or strainer loading. The ozone generator’s efficiency is optimized

near the center of the flow meter. The Eclipse ozone generator

will still perform well at flows above and below the recommended

range. However, the ball must be moving and not stuck on the

bottom of the flowmeter.

4E. Contact Information

For technical assistance:

Call: (805) 541-1601 ext. 293 or (800) 676-1335 ext. 293

Or visit our website: www.delozone.com

SECTION 5. Replacement Parts

5A. Ordering Information

To locate a dealer nearest you call 1.800.676.1335 ext. 232 or visit

www.delozone.com.

Be prepared with the following information:

• Name • Date Purchased

• Address • Dealer Name

• DEL Model #

1 2 ... 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Del ozone Spa-Eclipse Instalační manuál Strana 12